Code: SC361
Description: Revolver HP sensor error - Timing & Condition - The home position is not detected during 3 revolution of the revolver unit after the revolver motor turns on.
Causes: • Poor connection of connector • Dirty sensor • Defective sensor • Defective revolver motor • Defective revolver drive board • Defective I/O control board • Defective main control board
Remedy: 1. Check if the connector of sensor is properly connected. 2. Replace the revolver H.P. sensor if the voltage at CN216-B5 on the I/O control board does not change when covering the sensor with a piece of paper. NOTE: Make sure that the revolver unit is locked in this step. 3. If the revolver unit does not rotate; 1 Replace the revolver motor. 2 Replace revolver motor drive board. 3 Replace the I/O control board. 4 Replace the main control board. [ Signal Check ] • Revolver H.P.: CN216-B5 or TP107 on I/O control board