Code: SC457
Description: Image transfer belt cleaning unit position error - Timing & Condition • When the belt cleaning section touches the image transfer belt, the belt cleaning sensor signal stays LOW. • When the belt cleaning section releases from the image transfer belt. The belt cleaning sensor stays HIGH.
Causes: • Dirty Sensor • Defective sensor • Defective belt cleaning shift clutch • Defective drum peripheral component motor • Defective I/O control board • Defective main control board
Remedy: 1. Pull out and re-insert the image transfer belt unit. 2. Clean the image transfer belt cleaning H.P. sensor if it is dirty. 3. Replace the sensor. (Input Check: 5-803-012) 4. Replace the belt cleaning shift clutch. (Output Check: SP 5-804-036) 5. Replace the drum peripheral component motor. 6. Replace the I/O control board. 7. Replace the main control board. [ Signal Check ] • H.P.: CN219-B2 or TP108 on I/O control board