Code: SC326
Description: FGATE1 error - Timing & Condition - The main control board does not receive FGATE signal from the LD control board while the image transfer belt makes 3 revolution after the Start key is pressed or at certain timing during copy cycle. - FAGTE signal - This signal is generated at the LD control board certain timing after the LD control board receives the belt mark signal from the main control board in order to control the timing of the laser writing for color synchronization.
Causes: • Belt mark detection error • Electrical noise • Poor connection of connectors • Defective LD control board • Defective Main control board
Remedy: 1. Clean the belt mark located back side of the image transfer belt or replace the belt if the belt mark is dirty or peel off. 2. Clean the belt mark detection sensor if it is dirty. 3. Clean the bias terminals of development units if they are dirty. 4. Check if the harness connectors (CN605 & NC406) on the LD control board and main scanner IPU board are properly connected. 5. Check if the harness connectors (CN604 & CN306) on the LD control board and main control board are properly connected. 6. Replace the LD control board. 7. Replace the main control board. [ Signal Check ] • FGATE: CN604-A2 or TP22 on LD control board / CN306-A9 on main control board • Belt mark: CN220-A12, TP106, or CN212-B11 on I/O control board / CN303-B1, TP108, or CN306-B2 on main control board / CN604-B9 or TP31 on LD control board If the machine is equipped with the controller, 1. Check if the connectors (CN606 & CN101) on the LD control board and controller I/F board are properly set. 2. Check if the controller I/F board is properly connected. 3. Replace the interface board.