Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi SC327 — Ricoh Aficio Color 6110

Code: SC327

Description: FGATE2 error - Timing & Condition - In the double image mode, the main control board does not receive the 2nd FGATE signal from the LD control board while the image transfer belt makes 3 revolution after the Start key is pressed or at certain timing during copy cycle.
Causes: • Belt mark detection error • Electrical noise • Poor connection of connectors • Defective LD control board • Defective Main control board
Remedy: 1. Clean the belt mark located back side of the image transfer belt or replace the belt if the belt mark is dirty or peel off. 2. Clean the belt mark detection sensor if it is dirty. 3. Clean the bias terminals of development units if they are dirty. 4. Check if the harness connectors (CN605 & NC406) on the LD control board and main scanner IPU board are properly connected. 5. Check if the harness connectors (CN604 & CN306) on the LD control board and main control board are properly connected. 6. Replace the LD control board. 7. Replace the main control board. [ Signal Check ] • FGATE: CN604-A2 or TP22 on LD control board / CN306-A9 on main control board • Belt mark: CN220-A12, TP106, or CN212-B11 on I/O control board / CN303-B1, TP108, or CN306-B2 on main control board / CN604-B9 or TP31 on LD control board If the machine is equipped with the controller, 1. Check if the connectors (CN606 & CN101) on the LD control board and controller I/F board are properly set. 2. Check if the controller I/F board is properly connected. 3. Replace the interface board.

← Xem tất cả mã lỗi Ricoh Aficio Color 6110

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie