Code: SC503
Description: 3rd paper tray error - Timing & Condition - • The upper limit sensor stays HIGH when the pick-up solenoid turns off. • The upper limit sensor stays LOW 1.5 seconds after the tray bottom plate goes down. • The upper limit sensor stays HIGH 10 seconds after the tray bottom plate goes up. • The upper limit sensor stays HIGH 3 seconds after the tray bottom plate goes up again.
Causes: • Pick-up solenoid spring come off • Defective upper limit sensor • Defective tray bottom plate • Defective tray lift motor • Defective I/O control board • Defective main control board
Remedy: 1. Check if the spring of pick-up solenoid comes off. 2. Check if the sensor harness is properly connected. 3. Clean or replace the sensor and replace it if necessary (Input Check: SP 5-803-014 to 017). 4. Replace the tray bottom lever if it is broken. 5. Pull out the paper tray and check if the tray lift motor works properly (Output Check: SP 5-804-75 to 82) 6. Replace the I/O control board. 7. Replace the main control board. [ Signal Check ] • Limit sensor H.P.: CN224-A8 or TP215 on I/O control board [ Signal Check ] • Limit sensor H.P.: CN226-A8 or TP282 on I/O control board