Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi SC120 — Ricoh Aficio Color 6513

Code: SC120

Description: Scanner HP sensor does not turn on - Timing & Condition - • The scanner H.P. sensor does not turn on when the scanner moves back to the home position or at the home position check. • The sensor output at CN403-A1 stays HIGH (5V).
Causes: • Scanner motor out of synchronization (drive error) • Poor connection of connectors • Defective scanner HP sensor • Defective sub/main scanner IPU board • Defective main control board
Remedy: 1. In SP 5-804-104, stop supplying the current to the scanner motor. Check the output signal from the scanner H.P. sensor in SP 5-803-100 by moving the scanner manually. (0: Not actuated; 1: Actuated - at H.P.) 2. If the result of step 1 is OK; 1) Check the tension of the timing belt. 2) Check if the pulley is firmly secured. 3) Check if the scanner wire is properly wired 4) Check the connection of CN700, CN701, and CN702 on the scanner motor drive board. 5) Check a current through the harnesses. 6) Replace the scanner motor drive board. 7) Replace the scanner motor. 3. If the result of step 1 is not OK; 1) Make sure the harness is properly connected. 2) Check a current through the harnesses. 3) Replace the sensor. 4) Replace the sub and/or main scanner IPU board(s). 5) Replace the main control board. [Signal Check] • Scanner HP: CN403-A1 on the sub scanner IPU board

← Xem tất cả mã lỗi Ricoh Aficio Color 6513

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie