Code: SC326
Description: FGATE1 error - Timing & Condition - The main control board does not receive the FGATE signal from the LD control board. This can occur after the Start key is pressed (the image transfer belt makes 3 revolutions) or at certain timing points during the copy cycle. - FAGTE signal - This signal is generated at the LD control board after the board receives the belt mark signal from the main control board. This signal is used to synchronize laser writes for the different colors.
Causes: • Belt mark detection error • Electrical noise • Poor connection of connectors • Defective LD control board • Defective Main control board
Remedy: 1. Clean the belt mark (located back side of the image transfer belt) or replace the belt if the belt mark is dirty or has peeled off. 2. Clean the belt mark detection sensor. 3. Clean the development units’ bias terminals. 4. Make sure the harness connectors (CN605 & NC406) on the LD control board and main scanner IPU board are properly connected. 5. Make sure the harness connectors (CN604 & CN306) on the LD control board and main control board are properly connected. 6. Replace the LD control board. 7. Replace the main control board. [Signal Check] • FGATE: CN604-A2 or TP22 on LD control board / CN306-A9 on main control board • Belt mark: CN220-A12, TP106, or CN212- B11 on I/O control board / CN303-B1, TP108, or CN306-B2 on main control board /CN604-B9 or TP31 on LD control board If the machine is equipped with the controller, 1. Make sure the connectors (CN606 & CN101) on the LD control board and controller I/F board are properly installed. 2. Make sure the controller I/F board is properly connected. 3. Replace the interface board.