Code: SC450
Description: Paper transfer bias current error - Timing - When the paper transfer bias turns on during printing process - Condition - The feedback voltage is 4.8V or higher, or the PWM value is 50% or higher for 500ms continuously.
Causes: • Defective high voltage supply board (T2) • Defective I/O control board • Defective main control board • If the paper transfer belt does not touch the image transfer belt and the paper transfer belt bias is ON
Remedy: 1. Make sure the paper transfer belt unit rises to touch the image transfer belt during the copy cycle. 2. Make sure the high voltage cable and trigger lines are properly connected to the high voltage supply board (T2), I/O control board, and main control board. 3. Replace the high voltage supply board (T2). 4. Replace the I/O control board. 5. Replace the main control board. [Signal Check] • Feedback signal: CN221-A1, TP172, or CN211-A3 on I/O control board / CN302- A7 or TP105 on the main control board • PWM: CN221-A2 or TP138 on the I/O control board