Code: SC510
Description: Paper feed motor error - Timing & Condition - • The feedback signal from the motor is still out of range 1 second after the trigger signal was sent. • The feedback signal goes out of range for 2 seconds while the trigger signal is ON.
Causes: • Poor connections • Defective paper feed motor • Defective I/O control board • Defective main control board • Mechanical overload
Remedy: 1. Make sure it is properly connected to the I/O control board (CN230). 2. Replace the paper feed motor. (Output check: SP5-804-008 to 009) 3. Replace the I/O control board. 4. Replace the main control board. 5. Check the feed unit drive section for anything that might cause an overload. [Signal Check] • Motor OK: CN230-A1 or TP269 on the I/O control board