Code: SC524
Description: Duplex end fence jogger-- H.P. error - Timing & Condition - • The home position is still detected a few seconds after the end fence leaves the home position. • The home position is not detected 24 seconds after the end fence moves back into the home position.
Causes: • Duplex unit not installed properly • Excessive load • Poor connections • Defective end fence motor • Defective I/O control board
Remedy: 1. Pull out and re-insert the duplex unit. 2. Check that connector CN484 is properly connected to the duplex control board. 3. Check for anything that might cause the motor to overload. 4. Replace the end fence motor (Output Check: SP5-804 095 and 096). 5. Replace the I/O control board. [Signal Check] • Duplex End Fence H.P.: CN207-B7 or TP288 on the I/O control board