Code: SC547-01
Description: Zero cross error (relay-contact soldering) The zero cross signal is detected for 0.05 seconds three times even though the fusing lamp relay is off when turning on the main power.
Causes: • Fusing relay damage (contact open) • Fusing relay drive circuit fault • PSU fuse (24VS) blowout
Remedy: • Turn the main power supply switch OFF/ON. • If the fusing relay is damaged, replace the PSU. • Check the connection between PSU and control board, and replace harness and board if necessary. • If the PSU fuse (24VS) blows out, replace the PSU.