Code: SC355
Description: ID sensor error • One of the following conditions occurred when the ID sensor pattern was calibrated during printing: Vsp > 2.5V, Vsg < 2.5V, Vsp = 0V, Vsg = 0V • The following conditions occurred simultaneously when the ID sensor pattern was calibrated during printing: Vsg = 5V, PWM = 0 (LED current drop) • Error occurred during automatic adjustment of Vsg: Vsg output did not attain 4V, even with PWM = 1023 (maximum current for LED) Vsg output was greater than 4V, even with PWM=1 (no current for the LED)
Causes: • ID sensor dirty or defective • ID sensor harness disconnected, or connector damaged • BCU defective • High voltage power supply board (power pack) defective • Scanning system or image creation system malfunction
Remedy: • Replace the ID sensor harness. • Replace the ID sensor. • Replace the harness of the high voltage power supply board (power pack). • Replace the harness of the BCU. • Replace the BCU.