Code: SC504-21
Description: 4th Tray Lift Error (D787) • Lift motor ascent error detection During tray initialization (upper limit not detected/lower limit detection), the tray base plate is raised to check the tray base plate position, but the limit sensor is not detected although a predetermined time elapsed, for 3 times consecutively. (The message of resetting the tray is displayed when the both sensors detect the error consecutively 2 times or less.)
Causes: • Lift motor error/connector missing • Limit sensor error/connector missing • Harness broken • Bank control board defective • Foreign matter, such as paper scrap, is caught between the paper feed tray and the tray lift motor • Paper set fault
Remedy: • Reset the paper. • Remove the foreign matter. • Replace the motor. • Reset the connector. • Replace the harness. • Replace the sensor. • Replace the control board for the optional paper feed tray. • Replace the tray. • Replace the paper feed roller. • Replace the pick-up arm.