Code: 501
Description: Tray 1 lift malfunction
• The lift sensor is not activated within 10 seconds after the tray lift motor starts lifting the bottom plate.
• When the tray lowers, the tray lift sensor does not go off within 1.5 sec.
• Tray overload detected when the tray is set.
• The lower limit sensor of the LCT does not detect the lower limit within 10 sec.
• The lift sensor is not activated within 10 seconds after the tray lift motor starts lifting the bottom plate.
• When the tray lowers, the tray lift sensor does not go off within 1.5 sec.
• Tray overload detected when the tray is set.
• The lower limit sensor of the LCT does not detect the lower limit within 10 sec.
Causes: • Tray lift motor defective, disconnected
• Paper or other obstacle trapped between tray and motor
• Pick-up solenoid disconnected, blocked by an obstacle
• Too much paper loaded in tray Note (B246)
• At first, the machine displays a message asking the operator to reset the tray.
• This SC will not display until the operator has pulled the tray out and pushed it in 3 times.
• If the operator cycles the machine off/on before the 3rd opening and closing of the tray, the 3-count is reset.
• Paper or other obstacle trapped between tray and motor
• Pick-up solenoid disconnected, blocked by an obstacle
• Too much paper loaded in tray Note (B246)
• At first, the machine displays a message asking the operator to reset the tray.
• This SC will not display until the operator has pulled the tray out and pushed it in 3 times.
• If the operator cycles the machine off/on before the 3rd opening and closing of the tray, the 3-count is reset.