Code: SC509-00
Description: SI By-pass Side Fence Drive Motor Error SI by-pass tray performs control to drive the side fence, and bring it against the paper. If the drive does not stop after the maximum drive time set for each operation mode, the error is detected. 1. Side fence contact operation • Drive stop trigger: One side of the fence will be a non-contact state. • Maximum drive time: 1350 msec • Side fence drive motor: CW 2. Side fence pushing operation • Drive stop trigger: Both of the fences will be a contact state. • Maximum drive time: 4200 msec • Side fence drive motor: CCW If the error is detected, a message is displayed "after re-set the paper size in the paper can be pulled through the paper. Should fit the paper guide plate" that. Accumulated count of error detection are 3 (CW) or 13 (CCW), the SC is displayed on the operation panel. In addition, the accumulated count is reset under the following conditions. a Turn the power off/on b If the by-pass side fence is back correct adjustment c Return from sleep
Causes: • SI by-pass side fence drive motor connector missing, error, step out • SI by-pass side fence paper contact sensor connector missing, error • by-pass paper end sensor error
Remedy: • SI by-pass side fence drive motor connector reset or replacement • SI by-pass side fence paper contact sensor (front, rear) connector reset or replacement • SI by-pass paper end sensor connector reset or replacement