Code: 312-04
Description: Charge roller feed back voltage error: Ye. The feedback voltage of the charge AC for each color is 0.3V or less for consecutive 200ms after the charge AC is activated in the standard or half line speed.
Causes: • Disconnected/incorrect harness for the power pack • Damaged/incorrect PCU • Power pack failure • Disconnected harness/connector
Remedy: 1. Check the drum condition: Check the terminal to see if there is dust, damage, or deformation. Check the continuity as well. If not good, replace the PCDU. If the SC reoccurs, go to the next step. 2. Check all the related connectors are firmly connected: If not good, reconnect the connector. Check if the SC reoccurs by cycling the power off/on. If the SC reoccurs, go to the next step. 3. Check the mainframe condition: Check if there is dust on the terminal for charging, or any damage/ deformation. Check the continuity between the power packs and charging terminal. If the SC reoccurs, go to the next step. 4. Check the Power pack: Try installing a new power pack to determine whether the power pack is the cause. If the SC does not occur with the new one, the old power pack was defective. 5. Replace the BiCU. SC Tables 467