Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 491-00 — Ricoh Aficio MPC306

Code: 491-00

Description: High voltage power: Charge/Development bias output error Incorrect PWM signal is detected 10 times for consecutive 20 seconds.
Causes: Hardware related causes: • Contact failure • Loose connector (Controller side) • Grounding, open-circuit in the high voltage route • Arc discharge due to lack of space • Shorted harness (Controller side) • BiCU malfunction (Signal error) • Power pack (Development/Transfer) failure Load related causes: • Short-circuit • Arc discharge due to lack of space • Deteriorated drum (overcurrent) • Condensated drum (overcurrent) • Incorrect gap between drum and charge roller (incorrect PCDU) • PCDU not installed firmly
Remedy: First, cycle the main power off/on to check if this SC occurs again. If this SC reoccurs, do the following: 1. Remove and install the PCDU again to make sure that the PCDU is firmly set. Cycle the main power off/on to check if this SC occurs again. If the SC occurs again, go to the next step. 2. Check if there are scratches on the drum surface. If you can see the internal element of the drum (plain pipe) on the surface, go to the next step, because too much electricity can flow at this point, which caused the SC. 3. Replace the PCDU and cycle the main power off/on to check if this SC occurs again. 4. Reconnect the connector (CN561) on the BiCU and cycle the main power off/on. Be careful not to bend the connector pins when reconnecting. If the SC occurs again, go to the next step. 5. Reconnect the connector (CN801) on the power pack (charge/ development) and cycle the main power off/on. If the SC occurs again, go to the next step. 6. Remove and install the power pack (charge/development) again and cycle the main power off/on. Check if the spring near the power pack terminal bends and comes in contact with other contacts. Cycle the main power off/on to check if this SC occurs again. 7. Replace the power pack (charge/development) and cycle the main power off/on to check if the SC occurs again. 8. Replace the BiCU and cycle the main power off/on to check if the SC occurs again. 9. Make sure that the harnesses on the power pack (charge/development) are not shorted. If not good, replace the harness and cycle the main power off/on.

← Xem tất cả mã lỗi Ricoh Aficio MPC306

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie