Description: Finisher communication error. While the BCU communicates with an optional unit, an SC code is displayed if one of following conditions occurs. • The IPU receives the break signal which is generated by the peripherals only just after the main switch is turned on. • When the BCU does not receive an OK signal from a peripheral 100ms after sending a command to it. The IPU resends the command. The IPU does not receive an OK signal after sending the command 3 times.
Causes: • Cable problems • IPU problems • BCU problems • PSU problems in the machine • Main board problems in the peripherals
Remedy: • Check if the cables of peripherals are correctly connected. • Replace the PSU if no power is supplied to peripherals. • Replace the IPU or main board of peripherals. • Replace the BCU.