Description: Heating roller overheat: Center (hardware error) During stand-by mode or a print job, the detected heating roller temperature reaches 220°C.
Causes: • Defective AC controller board • Defective IOB • Defective IPU • Defective fusing control system
Remedy: 1. Replace the AC controller board. 2. Replace the IOB. 3. Replace the IPU. 4. Replace the fusing unit and reset the counter of the fusing unit using SP3-902-014. Important: The fusing unit cannot be used because an abnormal high temperature was detected. After this SC occurs, the counter reset of the fusing unit should be done manually using SP3-902-014 because the counter reset is not done automatically.