Code: 500
Description: Transport/Fusing Motor Error
The LOCK signal error is detected when the EGB monitors the transport/fusing motor state. (This monitoring is done immediately after power-on, when the motor starts rotating, and immediately after the motor stops.)
The LOCK signal error is detected when the EGB monitors the transport/fusing motor state. (This monitoring is done immediately after power-on, when the motor starts rotating, and immediately after the motor stops.)
Causes: Disconnected or defective motor harness. Motor slips due to excessive load.
Remedy: 1. Check the harness from the transport/fusing motor. Replace it if necessary.