Code: 441-00
Description: Transfer motor error
Early Detection • A command to stop the rotation of the motor has been issued right after the power was turned on, but the motor is still rotating. Motor Operation Timing • When the motor rotation request or speed change request is issued, the motor is in the stopped state. Motor Stop Timing A command to stop the rotation of the motor has been issued, but the motor is still rotating.
Early Detection • A command to stop the rotation of the motor has been issued right after the power was turned on, but the motor is still rotating. Motor Operation Timing • When the motor rotation request or speed change request is issued, the motor is in the stopped state. Motor Stop Timing A command to stop the rotation of the motor has been issued, but the motor is still rotating.
Causes: • Disconnected connector • Broken signal wire • Excessive motor torque • Torque of the Image Transfer Unit is too large • Torque of the Waste Toner processing system is too large • Failed Paper Exit Full Sensor
Remedy: • Check the connector connection • Turn the power OFF and then ON • Replace the Image Transfer Unit Motor. • Replace the Image Transfer Unit • Replace the Waste Toner Duct • Replace the Paper Exit Full Sensor