Code: 544
Description: Fusing sleeve belt overheat: Center (hardware error)
During stand-by mode or a print job, the detected fusing sleeve belt temperature reaches 250°C.
During stand-by mode or a print job, the detected fusing sleeve belt temperature reaches 250°C.
Causes: Defective PSU. Defective BCU. Defective AC control board. Defective IOB. Defective fusing control system.
Remedy: • Replace the PSU. • Replace the BCU. • Replace the AC controller board. • Replace the IOB. Replace the fusing unit and reset the counter of the fusing unit using SP3-902-014. Important: • The fusing unit cannot be used because an abnormal high temperature was detected. After this SC occurs, the counter reset of the fusing unit should be done manually using SP3-902-014 because the counter reset is not done automatically. • After replacing fusing unit, to set SP5-810-2 is necessary to reset this SC.