Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon i-SENSYS LBP3370

Code: A4-XX

Description: There is a fault in the software program of the video controller.
Causes:
Remedy: - Turn off and then back on the power. - Replace the video controller board.

Code: A5-XX

Description: A fault has occurred in image processing within the controller
Causes:
Remedy: 1. Turn off and then back on the power. 2. If remedy 1 above fails, increase the memory. 3. If remedy 2 above fails, replace the controller board.

Code: A7-XX

Description: There is an error in the software program of the video controller.
Causes:
Remedy: 1. Turn off and then back on the power. 2. If remedy 1 above fails, replace the controller board.

Code: D7-XX

Description: A fault has occurred the firmware of the PCL translator.
Causes:
Remedy: 1. Turn off and then on the power. 2. If remedy 2 above fails, replace the controller board.

Code: D8-XX

Description: A fault has occurred in the firmware of the LIPS LX (BLD) translator.
Causes:
Remedy: 1) Turn on the power. 2) If step 1 fails, replace the controller board.

Code: E000-0000

Description: Fixing fault
Causes: The temperature of the fixing unit does not reach the targeted temperature -10 deg C within 63 sec. after the wait sequence is started. Cause The fixing film unit is faulty. The engine controller PCB is faulty.
Remedy: - Replace the fixing film unit. - Replace the engine controller PCB.

Code: E001-0000

Description: Fixing error high temperature
Causes: The fixing unit temperature is monitored every 5 msec., and the temperature exceeds 220 deg C for 30 times continuously. Cause The main thermistor is faulty. The engine controller PCB is faulty.
Remedy: - Replace the fixing film unit. - Replace the engine controller PCB.

Code: E003-0000

Description: Fixing low temperature.
Causes: The temperature of the thermistor is detected every 5 msec. during the control and it shows under 20 deg C for 100 times continuously after the temperature of the fixing unit exceeds 50 deg C at least once. Cause The main thermistor is faulty. The engine controller PCB is faulty. The connector is in poor contact. The harness is faulty.
Remedy: - Replace the fixing film unit. - Replace the engine controller PCB.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie