• Code: E805-0003
• Description: Fan failure
• Causes: Controller fan failure detected The controller fan does not rotate because some kind of failure occurred in it.
• Remedy: Replace the controller fan.

• Code: E805-0006
• Description: Fan failure
• Causes: Power supply fan failure The fan did not rotate even when 12 seconds elapsed after the motor rotation start order was received.
• Remedy: • Reconnect the connector J21 on the DC controller PCB and the connector J106 on the low-voltage power supply unit. • If the voltage between the connectors J21-2 and J25-2 on the DC controller PCB is changed from 0V to approximately 24V immediately after the printer is turned on, replace the power supply fan.

• Code: E806-0001
• Description: Delivery fan error
• Causes: Delivery fan error
• Remedy: • Check the connection of the connector. • Replace the fan. • Check the harness (check for disconnected/pinched harness)

• Code: E808-0001
• Description: Error in low voltage power supply
• Causes: Low-voltage power supply failure
• Remedy: Replace the Low-voltage power supply unit.

• Code: E825-0000
• Description: Drum phase control sensor failure warning
• Causes: Yellow drum phase control sensor failure warning • A slit was not detected for 4 seconds after slit detection started. • An abnormal slit width was detected.
• Remedy: • Check the YMC drum drive gear. • Replace the YMC drum HP sensor (PS13).

• Code: E825-0001
• Description: Drum phase control sensor failure warning
• Causes: Magenta drum phase control sensor failure warning • A slit was not detected for 4 seconds after slit detection started. • An abnormal slit width was detected.
• Remedy: • Check the YMC drum drive gear. • Replace the YMC drum HP sensor (PS13).

• Code: E825-0002
• Description: Drum phase control sensor failure warning
• Causes: Cyan drum phase control sensor failure warning • A slit was not detected for 4 seconds after slit detection started. • An abnormal slit width was detected.
• Remedy: • Check the YMC drum drive gear. • Replace the YMC drum HP sensor (PS13).

• Code: E825-0003
• Description: Drum phase control sensor failure warning
• Causes: Black drum phase control sensor failure warning • A slit was not detected for 4 seconds after slit detection started. • An abnormal slit width was detected.
• Remedy: • Check the Bk drum drive gear. • Replace the Bk drum HP sensor (PS12).