Code :

Code: E000 0000
Description: Temperature rise error
Remedy: 1) Reconnect the connector on the Engine Controller PCB. 2) Turn OFF the power supply switch, and remove the Fixing Assembly. Measure the resistance value between the connector (FSRTH) at the Fixing Assembly side and grounding. If the resistance value is not between 368k ohm and 512k ohm (normal temperature), replace the Fixing Assembly. 3) If the connector at the Fixing Assembly side does not have induction while the assembly is removed, replace the assembly 4) Replace the Engine Controller PCB.

Code: E001 0000
Description: High temperature error 1
Remedy: 1) Reconnect the connector on the Engine Controller PCB. 2) Turn OFF the power supply switch, and remove the Fixing Assembly. Measure the resistance value between the connector (FSRTH) at the Fixing Assembly side and grounding. If the resistance value is 1k ohm or lower, replace the Fixing Assembly. 3) Replace the Engine Controller PCB.

Code: E003 0000
Description: Low temperature error 1
Remedy: 1) Reconnect the connector on the Engine Controller PCB. 2) Turn OFF the power supply switch, and remove the Fixing Assembly. Measure the resistance value between the connector (FSRTH) at the Fixing Assembly side and grounding. If the resistance value is not between 368k ohm and 512k ohm (normal temperature), replace the Fixing Assembly. 3) If there is no induction between the connector (ACN) at the Fixing Assembly side and the connector (ACH) while the assembly is removed, replace the assembly 4) Replace the Engine Controller PCB.

Code: E004 0000
Description: Drive circuit unit error
Remedy: 1) Reconnect the connector on the Engine Controller PCB. 2) Check the source of power supply for the printer. When using the power supply from the power generator and the like, improve the source of power supply. Note: If the frequency of power supply is not the specified range (40Hz to 70Hz), the fixing temperature control is not executed normally, so this might cause the damage. 3) Replace the Engine Controller PCB.

Code: E014 0000
Description: Main Motor malfunction
Remedy: 1) Reconnect the connector on the Main Motor. 2) Replace the Main Motor.

Code: E100 0000
Description: Optical Unit malfunction
Remedy: 1) Reconnect the connector on the Laser Scanner Unit. 2) Replace the Laser Scanner Unit.

Code: E602 0002
Description: Bootable load failure A Bootable CD was not contained. A Bootable CD was damaged
Remedy: 1) Burn the Bootable CD again.

1 2 >