• Code: 2F88
• Display: Colorimetric readout error. Please press OK and execute color measuring again.
• Description: When reading the positioning bar, a value other than predetermined value was returned.
• Remedy: 1. Operate paper feed adjustment. 2. Printer support (In case of printing failure). 3. Replace spectrophotometer sensor.

• Code: 2F89
• Display: Colorimetric readout error. Please press OK and execute color measuring again
• Description: 1) No shifting amount detected from the positioning bar reading value. 2) Position shifting exceeded the threshold value. 3) Skew exceeded the threshold value.
• Remedy: 1. Operate paper feed adjustment. 2. Printer support (In case of printing failure). 3. Replace spectrophotometer sensor

• Code: 2F90
• Display:
• Description: Detected 3V of abnormal power out from the printhead. (Latch up current flows at head logic and temporarily the print head falls into abnormal state ; it is possible to recover by power on and off.)
• Remedy:

• Code: 2FA0
• Display: It is recommended to clean the white calibration board to prevent it from possible dirt
• Description: Inform the calibration timing of the spectrophotometer sensor.
• Remedy: Calibrate the spectrophotometer sensor.

• Code: 4001
• Display: ERROR E146-4001 Call for service.
• Description: Borderless/flow pre-ejection/mist recovery count full
• Remedy: Check the parts counter and replace the target unit or Refresh Service Kit. Initialize the parts counter for the target unit after the replacement.

• Code: 401A
• Display: ERROR E602-401A Call for service.
• Description: HDD failure Failed to read and write to and from the HDD.
• Remedy: 1. Restart in service mode. 2. Remove and install HDD 3. Replace HDD. Switch on service mode after the replacement.

• Code: 401B
• Display: ERROR E602-401B Call for service.
• Description: Poor HDD connection The HDD and the HDD controller are not indefinable.
• Remedy: 1. Restart in service mode. 2. Remove and install HDD 3. Replace HDD. Switch on service4. Replace HDD controller or the main controller PCB. Restart after the replacement.

• Code: 401C
• Display: ERROR E198-401C Call for service.
• Description: Faulty RTC Any error other than the two errors mentioned below has been detected while initializing the RTC at startup.
• Remedy: 1. Restart the printer in service mode. 2. Replace the main controller PCB.