Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon iPF785 — Trang 33/39

Code: 2F88

Display: Colorimetric readout error. Please press OK and execute color measuring again.
Description: When reading the positioning bar, a value other than predetermined value was returned.
Remedy: 1. Operate paper feed adjustment. 2. Printer support (In case of printing failure). 3. Replace spectrophotometer sensor.

Code: 2F89

Display: Colorimetric readout error. Please press OK and execute color measuring again
Description: 1) No shifting amount detected from the positioning bar reading value. 2) Position shifting exceeded the threshold value. 3) Skew exceeded the threshold value.
Remedy: 1. Operate paper feed adjustment. 2. Printer support (In case of printing failure). 3. Replace spectrophotometer sensor

Code: 2F90

Display:
Description: Detected 3V of abnormal power out from the printhead. (Latch up current flows at head logic and temporarily the print head falls into abnormal state ; it is possible to recover by power on and off.)
Remedy:

Code: 2FA0

Display: It is recommended to clean the white calibration board to prevent it from possible dirt
Description: Inform the calibration timing of the spectrophotometer sensor.
Remedy: Calibrate the spectrophotometer sensor.

Code: 4001

Display: ERROR E146-4001 Call for service.
Description: Borderless/flow pre-ejection/mist recovery count full
Remedy: Check the parts counter and replace the target unit or Refresh Service Kit. Initialize the parts counter for the target unit after the replacement.

Code: 401A

Display: ERROR E602-401A Call for service.
Description: HDD failure Failed to read and write to and from the HDD.
Remedy: 1. Restart in service mode. 2. Remove and install HDD 3. Replace HDD. Switch on service mode after the replacement.

Code: 401B

Display: ERROR E602-401B Call for service.
Description: Poor HDD connection The HDD and the HDD controller are not indefinable.
Remedy: 1. Restart in service mode. 2. Remove and install HDD 3. Replace HDD. Switch on service4. Replace HDD controller or the main controller PCB. Restart after the replacement.

Code: 401C

Display: ERROR E198-401C Call for service.
Description: Faulty RTC Any error other than the two errors mentioned below has been detected while initializing the RTC at startup.
Remedy: 1. Restart the printer in service mode. 2. Replace the main controller PCB.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie