Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon iPF815 — Trang 4/6

Code: E196-4045

Description: Engine EEPROM write error An EEPROM read/write failure has been detected in the engine portion of the firmware.
Remedy: 1. Start in download mode to upgrade the firmware. 2. Restart the printer in service mode to clear the error. 3. Replace the main controller PCB.

Code: E196-404C

Description: Serial number information mismatch A mismatch has been detected between the serial number information stored in the EEPROM on the main controller PCB and that stored in the EEPROM on the MTC relay PCB at startup.
Remedy: 1. Check to see if the correct PCB is mounted, since a PCB of the wrong model may have been mistakenly mounted during servicing. 2. Invoke service mode to implement PCB replacement.

Code: E196-404D

Description: Machine ID information mismatch A mismatch has been detected between the model ID information stored in the EEPROM on the main controller PCB and that stored in the EEPROM on the MTC relay PCB at startup.
Remedy: 1. Check to see if the correct PCB is mounted, since a PCB of the wrong model may have been mistakenly mounted during servicing. 2. Invoke service mode to implement PCB replacement.

Code: E196-404E

Description: An EEPROM read/ write error has been detected in the controller portion of the firmware.
Remedy: 1. Start in download mode to upgrade the firmware. 2. Start in service mode to clear the error. 3. Replace the main controller PCB.

Code: E198-401C

Description: Faulty RTC Any error other than the two errors mentioned below has been detected while initializing the RTC at startup.
Remedy: 1. Restart the printer in service mode. 2. Replace the main controller PCB.

Code: E198-401D

Description: RTC low battery error A battery error has been detected while initializing the RTC at startup.
Remedy: 1. Restart the printer in service mode. 2. Check the RTC battery. 3. Replace the main controller PCB.

Code: E198-401E

Description: RTC clock stop The RTC has been detected idle while initializing the RTC at startup.
Remedy: 1. Restart the printer in service mode. 2. Replace the main controller PCB.

Code: E199-404B

Description: Temperature/humidity sensor error When temperature 0 and humidity 0% are detected, the detection mechanism is considered failed and an error message is displayed.
Remedy: 1. Restart the printer in service mode to clear the error. 2. Identify the firmware version and update the firmware to the last release if it is earlier than Ver.1.31 (firmware defect). 3. Remove and reinsert the temperature/humidity sensor PCB connector 4. Replace the temperature/humidity sensor PCB.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie