• Code: E247-0004
• Description: System error
• Remedy: Contact to the sales companies.

• Code: E248-0001
• Description: EEPROM error of the CCD unit
  An error has occurred at power-on.
• Remedy: 1. Disconnect and then connect the flexible cable(CCD unit- Reader Controller PCB (UN4)). 2. Replace the flexible cable. 3. Replace the CCD unit.

• Code: E248-0002
• Description: EEPROM error of the CCD unit
  An error has occurred during write operation
• Remedy: 1. Disconnect and then connect the flexible cable(CCD unit- Reader Controller PCB (UN4)). 2. Replace the flexible cable. 3. Replace the CCD unit.

• Code: E248-0003
• Description: EEPROM error of the CCD unit
  An error has occurred during read operation following write operation.
• Remedy: 1. Disconnect and then connect the flexible cable(CCD unit- Reader Controller PCB (UN4)). 2. Replace the flexible cable. 3. Replace the CCD unit.

• Code: E261-0000
• Description: Error in Zero Cross
  Zero Cross failed to be detected for 500ms or more while the relay was ON. * The same condition is detected after the error retry is performed.
• Remedy: 1. Check the Connectors. (J113/J202) 2. Replace the Power supply PCB (UN1). 3. Replace the DC Controller PCB (UN2).

• Code: E280-0003
• Description: Reading unit communication error
  Reading error after writing.
• Remedy: 1. Disconnect and then connect the flexible cable(Reader Controller PCB (UN4)-Main Controller PCB 2 (UN14)). 2. Disconnect and then connect the flexible cable(CCD unit- Main Controller PCB 2 (UN14)). 3. Replace the flexible cable. 4. Replace the Reader Controller PCB (UN4). 5. Replace the Main Controller PCB 2 (UN14).

• Code: E315-0007
• Description: Codec error
  JBIG encode error.
• Remedy: Replacement of the Main Controller PCB.

• Code: E315-000d
• Description: Codec error
  JBIG decode error
• Remedy: 1. Replace the SDRAM. 2. Replace the HDD. 3. Replace the Main Controller PCB