Code :

Code: 602-5001-00
Description: HDD error
Causes: Mistake in the procedure for installing the HDD optional board
Remedy: Perform the following in the order while checking whether the error is cleared. 1. Remove the HDD optional board. Then connect only the HDD and turn ON the power. 2. Execute COPIER> FUNCTION> INSTALL> HD-CRYP. 3. Install the HDD optional board.

Code: 602-5002-00
Description: HDD error
Causes: A non-genuine HDD was detected.
Remedy: 1. Replace the HDD with a genuine one. 2. Format the HDD and reinstall the system software using SST or a USB flash drive.

Code: 602-FF01-00
Description: HDD error
Causes: An unidentified HDD error was detected at startup. When this error occurs, the system has not been started normally. Therefore, it may not be recorded in the error log.
Remedy: [Related parts] R1.00 - Harnesses between the Main Controller PCB and the HDD - Main Controller PCB - HDD [Remedy] Perform the following in the order while checking whether the error is cleared. 1. Check the related harness/cable and connector. 2. Format the HDD and reinstall the system software using SST or a USB flash drive. 3. Check/replace the related parts. [Reference] For backup and restoration, refer to "Adjustment> Main Controller System" and "Appendix> Backup Data List" in the Service Manual.

Code: 602-FF11-00
Description: HDD error
Causes: An unidentified HDD error was detected after startup.
Remedy: [Related parts] R1.00 - Harnesses between the Main Controller PCB and the HDD - Main Controller PCB - HDD [Remedy] Perform the following in the order while checking whether the error is cleared. 1. Check the related harness/cable and connector. 2. Format the HDD and reinstall the system software using SST or a USB flash drive. 3. Check/replace the related parts. [Reference] For backup and restoration, refer to "Adjustment> Main Controller System" and "Appendix> Backup Data List" in the Service Manual.