• Code: E315-0541
• Description: Device abnormal completion
  An abnormal signal from the Main Controller PCB to the Reader is detected.
• Remedy: 1. Turn OFF and then ON the main power.
  2. Check the connection of the Main Controller PCB (including the flat cable).
  3. Replace the flat cable.
  4. Replace the Main Controller PCB (PCB2).

• Code: E315-0550
• Description: Device timeout
  An image synchronous signal from the Main Controller PCB to the Reader is not received within 30 seconds.
• Remedy: 1. Turn OFF and then ON the main power.
  2. Check the connection of the Main Controller PCB (including the flat cable).
  3. Replace the flat cable.
  4. Replace the Main Controller PCB (PCB2).

• Code: E315-0551
• Description: Device abnormal completion
  An abnormal signal from the Main Controller PCB to the Reader is detected.
• Remedy: 1. Turn OFF and then ON the main power.
  2. Check the connection of the Main Controller PCB (including the flat cable).
  3. Replace the flat cable.
  4. Replace the Main Controller PCB (PCB2).

• Code: E350
• Description: System error
• Remedy: Contact the service company office

• Code: E351-0000
• Description: Main Controller PCB communication error
• Remedy: 1. Turn OFF and then ON the main power
  2. Disconnect and then connect the connector of the Main Controller PCB.
  3. Replace the Main Controller PCB (PCB2).

• Code: E354
• Description: System error
• Remedy: Contact the service company office

• Code: E355
• Description: System error
• Remedy: Contact the service company office

• Code: E500-0000
• Description: Communication error
  As for the communication with the Finisher and the Host Machine, the retry of the communication was over the specified number of times.
• Remedy: 1. Check the installation of the Host Machine and the Finisher.
  2. Check the connector connection between the DC Controller PCB (PCB1) and the Finisher Controller PCB (PCB1).
  3. Replace the Finisher Controller PCB (PCB1).
  4. Replace the DC Controller PCB (PCB1).