• Code: E713-0020
• Description: Finisher IPC communication error (recovery error)
  Communication between the host machine and the Finisher was lost.
• Remedy: 1. Check the cable connection of the Finisher. DC Controller side: J462, Finisher Lattice side: J9043 2. Replace the Finisher Controller PCB.

• Code: E713-0040
• Description: Finisher IPC communication error (serial error)
  Communication between the host machine and the Finisher was lost.
• Remedy: 1. Check the cable connection of the Finisher. DC Controller side: J462, Finisher Lattice side: J9043 2. Replace the Finisher Controller PCB.

• Code: E717-0001
• Description: Communication error with the NE Controller
  Error when the NE Controller is started. The NE Controller which was connected before turning OFF the power is not connected at power-on.
• Remedy: Check the cable, and then go through the following to clear the error: Service Mode > COPIER > FUNCTION > CLEAR > ERR.

• Code: E717-0002
• Description: Communication error with the NE Controller
  IPC error at NE Controller operation. Open circuit of IPC, unable to recover the IPC communication.
• Remedy: Check the cable, and then go through the following to clear the error: Service Mode > COPIER > FUNCTION > CLEAR > ERR.

• Code: E719-0001
• Description: Error in coin manager
  Error when the coin manager is started. The coin manager which was connected before turning OFF the power is not connected at power-on.
• Remedy: Check the cable, and then go through the following to clear the error: Service Mode > COPIER > FUNCTION > CLEAR > ERR.

• Code: E719-0002
• Description: Error in coin manager
  IPC error at coin manager operation. Open circuit of IPC, unable to recover the IPC communication. When open circuit of the pickup/delivery signal cable is detected. Invalid connection is detected.
• Remedy: Check the cable, and then go through the following to clear the error: Service Mode > COPIER > FUNCTION > CLEAR > ERR.

• Code: E719-0003
• Description: Error in coin manager
  Communication error with the coin manager occurs during unit price acquisition at startup.
• Remedy: Check the cable, and then go through the following to clear the error: Service Mode > COPIER > FUNCTION > CLEAR > ERR.

• Code: E719-0011
• Description: Error when the Card Reader is started
  The Card Reader which was connected before turning OFF the power is not connected at power-on.
• Remedy: Check the cable, and then go through the following to clear the error: Service Mode > COPIER > FUNCTION > CLEAR > ERR.