• Code: E023-0002
• Description: Error in Magnet Roller Clutch connection detection. Connection of the Magnet Roller Clutch (CL5) cannot be detected 5 times with 20 msec time interval.
• Remedy: 1. Check the connection of the Magnet Roller Clutch (CL5). Sensor side: J2006, Main Driver PCB (PCB2) side: J109 2. Replace the Magnet Roller Clutch (CL5). 3. Replace the Main Driver PCB (PCB2). 4. Replace the DC Controller PCB (PCB1).

• Code: E025-0001
• Description: Toner Feed Motor error. Overcurrent of the Toner Feed Motor (M28) was detected.
• Remedy: 1. Check the connection of the Connector. Motor side: J2036, Buffer Unit relay: J3124, Front side relay: J3090, Rear side relay: J3091, Main Driver PCB (PCB2) side: J115 2. Replace the Toner Feed Motor (M28). 3. Check if toner is clogged inside of the Buffer. Turn the Drive Shaft of the Motor with your hand to check it. If the load is too much, inside of the Buffer may be clogged, so clean inside of it. 4. Replace the Main Driver PCB (PCB2). 5. Replace the DC Controller PCB (PCB1).

• Code: E027-0001
• Description: Toner Supply Motor error. Lock error of the Toner Supply Motor (M10).
• Remedy: 1. Check the connection of the Connector. Motor side: J2037, Front side relay: J3080, Rear side relay: J3063, Main Driver PCB (PCB2) side: J117 2. Remove the Toner Container, and check if an error occurs. If an error does not occur, reinstall the Toner Container and check again. If an error occurs, check the driving area of connection point of the container. If an error occurs, go on to 3. 3. Replace the Toner Supply Motor (M10). 4. Replace the Main Driver PCB (PCB2). 5. Replace the DC Controller PCB (PCB1).

• Code: E032-0001
• Description: Failure of NE Controller Counter. Detection of open circuit of count pulse signal.
• Remedy: Disconnection of cable.

• Code: E041-0001
• Description: Right Deck Lifter Motor error. Overcurrent of the Right Deck Lifter Motor was detected.
• Remedy: 1. Check for displacement of the Lifter Wire of the Right Deck. 2. Check for hindrance to smooth movement of the Deck Base Plate of the Right Deck

• Code: E041-0002
• Description: Left Deck Lifter Motor error. Overcurrent of the Left Deck Lifter Motor was detected.
• Remedy: 1. Check for displacement of the Lifter Wire of the Left Deck. 2. Check for hindrance to smooth movement of the Deck Base Plate of the Left Deck.

• Code: E041-0003
• Description: Cassette 3 Lifter Motor error. Overcurrent of the Cassette 3 Lifter Motor was detected.
• Remedy: 1. Check for error around the Lifter of the Cassette 3. 2. Check for hindrance to smooth movement of the Cassette Base Plate of the Cassette 3.

• Code: E041-0004
• Description: Cassette 4 Lifter Motor error. Overcurrent of the Cassette 4 Lifter Motor was detected.
• Remedy: 1. Check for error around the Lifter of the Cassette 4. 2. Check for hindrance to smooth movement of the Cassette Base Plate of the Cassette 4.