Code :

Code: E713-0002
Description: Finisher communication error 2
A large amount of data from the Finisher causes data overflow
Remedy: Turn OFF and then ON the main power

Code: E713-0003
Description: Finisher communication error 3
A large amount of data from the Finisher causes the reception buffer overflow
Remedy: Turn OFF and then ON the main power?a

Code: E713-0005
Description: Finisher communication error 5
The DC Controller sent a command to the Finisher three times, but no response was received.
Remedy: 1. Check cable connection between the Finisher and the host machine. 2. Turn OFF and then ON the main power.

Code: E713-0006
Description: Finisher communication error 6
Error signal was received for 3 times in a row
Remedy: Turn OFF and then ON the main power

Code: E713-0007
Description: Finisher communication error 7
Overflow of driver buffer due to many requests from the upper task before the process of the driver
Remedy: Turn OFF and then ON the main power

Code: E713-0008
Description: Removing the Finisher
Removal of the Finisher from the host machine was detected.
Remedy: Turn OFF and then ON the main power.

Code: E719-0001
Description: Coin vendor error
Error when the coin vendor is started - The Coin Vendor, which must have been connected before the power was turned OFF, is not connected when the power is turned ON
Remedy: Check cable connection between the charging management equipment and the host machine While the charging management equipment is connected for operation, clear the error in the case of switching to the operation without the charging management equipment (To prevent a misuse by removing the charging management equipment, this error code is displayed)