• Code: E674-000C
• Description: FAX Board communication error
  An error was detected in access of the modem IC or port IC used by Fax
• Remedy: Note: Note: For the part described as the Main Control PCB, it indicates Main Controller PCB 2 when the FAX Board is for 1 line, and Main Controller PCB 1 when the FAX Board is for 2 lines. 1. Check wire connection between the FAX Board and the Main Controller PCB 2. Replace the FAX Board 3. Replace the Main Controller PCB

• Code: E674-0010
• Description: FAX Board communication error
  Error in timer device to be used by FAX at activation
• Remedy: Note: For the part described as the Main Control PCB, it indicates Main Controller PCB 2 when the FAX Board is for 1 line, and Main Controller PCB 1 when the FAX Board is for 2 lines. Replace the Main Controller PCB

• Code: E674-0011
• Description: FAX Board communication error
  Error when the timer device to be used by FAX is started
• Remedy: Note: For the part described as the Main Control PCB, it indicates Main Controller PCB 2 when the FAX Board is for 1 line, and Main Controller PCB 1 when the FAX Board is for 2 lines. Replace the Main Controller PCB

• Code: E674-0030
• Description: FAX Board communication error
  Checksum error of USB-FAX MAINROM
• Remedy: When the power is turned ON, get in the download mode from service mode to execute downloading of USBFAX MAINROM

• Code: E677-0003
• Description: Print server error
  Error is detected by checking of the mother board at startup of the print server
• Remedy: 1. Check cable connection and turn ON the power again 2. Reinstall the printer server

• Code: E710-0001
• Description: IPC initialization error
  Unable to be ready within 3 sec after IPC chip was started
• Remedy: Check the connection cable between the DC Controller PCB and the Finisher

• Code: E711-0001
• Description: IPC register error
  4 or more errors are set to the error register of the IPC chip in 1.5 sec
• Remedy: Check the connection cable between the DC Controller PCB and the Finisher

• Code: E713-0001
• Description: Finisher communication error 1
  Continuous interruption to RX communication from the Finisher (Finisher down is detected)
• Remedy: Turn OFF and then ON the main power