Code :

Code: E719-0003
Description: Error in Coin Vendor.
- In the case of communication error with the coin vendor while obtaining the unit price at start-up.
Remedy: Check the connection between charging management equipment and machine, and check that the Cable is not open-circuit. Clear the error while the charging management equipment is connected to operate and when switching to the operation without charging management equipment. (To prevent the misuse by removing the charging management equipment, this error code is displayed.)

Code: E719-0011
Description: Error in Coin Vendor.
Error in starting of NewCardReader - NewCardReader, which should have been connected before the power was turned OFF, is not connected when the power is turned ON.
Remedy: Check the connection between charging management equipment and machine, and check that the Cable is not open-circuit. Clear the error while the charging management equipment is connected to operate and when switching to the operation without charging management equipment. (To prevent the misuse by removing the charging management equipment, this error code is displayed.)

Code: E719-0012
Description: Error in Coin Vendor.
Error in IPC when NewCardReader is running. - In the case of disconnection of IPC or an error in which IPC communication failed to be recovered.
Remedy: Check the connection between charging management equipment and machine, and check that the Cable is not open-circuit. Clear the error while the charging management equipment is connected to operate and when switching to the operation without charging management equipment. (To prevent the misuse by removing the charging management equipment, this error code is displayed.)

Code: E719-0031
Description: Error in serial communication at the start of the New Card Reader
Failure in communication with the serial New Card Reader at start-up.
Remedy: - Check if the cable of the serial New Card Reader is disconnected. - Take out the serial New Card Reader. - COPIER > Function > CLEAR > CARD - COPIER > Function > CLEAR > ERR

Code: E719-0032
Description: Error in serial communication at the start of the New Card Reader
Communication failed in the middle of the operation although communication with the serial New Card Reader was successful at start-up.
Remedy: - Check if the cable of the serial New Card Reader is disconnected.

Code: E720-0001
Description: Error due to non-compatible Finisher
Non-compatible Finisher was connected.
Remedy: Connect either the Staple Finisher-J1 or Saddle Stitch Finisher-J1.