• Code: 0104
• Description: Pickup Delay Jam SR11
  - After execution of a pickup retry, the registration sensor (SR11) does not detect the leading edge of paper within a specific period of time. Or after the duplex drive solenoid (SL1) is on, the registration sensor (SR11) does not detect the leading edge of paper within a specific period of time.
• Remedy:

• Code: 010c
• Description: Delivery Sensor Delay Jam SR5
  - After the registration sensor (SR11) has detected the leading edge of paper, the delivery sensor (SR5) does not detect the leading edge of paper within a specific period of time.
• Remedy:

• Code: 0208
• Description: Pickup Stationary Jam SR11
  - After the registration sensor (SR11) has detected the leading edge of paper, the registration sensor (SR11) does not detect the trailing edge of paper within a specific period of time.
• Remedy:

• Code: 0210
• Description: Delivery Sensor Stationary Jam SR5
  - The delivery sensor cannot detect absence of paper within the specified time after turning off of the registration clutch. - The delivery sensor cannot detect absence of paper within the specified time after the sensor detected the leading edge of paper.
• Remedy:

• Code: 0214
• Description: Stationary jam in machine SR5, SR9
  - After the registration sensor (SR11) has detected the trailing edge of paper, the delivery sensor (SR5) does not detect the trailing edge of paper within a specific period of time.
• Remedy:

• Code: 021c
• Description: Wound Paper Jam at Fuser SR5, SR11
  - The delivery sensor (SR5) has detected absence of paper within the prescribed time after it detected presence of paper.
• Remedy:

• Code: 1118
• Description: Door open jam SR5, SR9, SR11, SW2
  - The door was opened when there was printing paper in the transport path.
• Remedy:

• Code: E000-0000
• Description: Startup error
  - The temperature detected by the main or sub thermistor does not rise to the specified value during startup control.
• Remedy: - Check the fixing film connector. - Replace the fixing film unit. - Replace the DC controller PCB.