Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon iR2530 — Trang 7/9

Code: E571-0001

Description: Gripper Open/Close Motor (M7) error
The gripper unit does not leave the gripper unit home position when the Gripper Open/Close Motor (M7) has been driven for 0.25 seconds.
Remedy: 1.Replace the Grip Arm Sensor (S13). 2.Replace the Gripper Open/Close Motor (M7). 3.Replace the Finisher Controller PCB (PCB1).

Code: E571-0002

Description: Gripper Open/Close Motor (M7) error
The gripper unit does not return to the gripper unit home position when the Gripper Open/Close Motor (M7) has been driven for 0.15 seconds.
Remedy: 1.Replace the Grip Arm Sensor (S13). 2.Replace the Gripper Open/Close Motor (M7). 3.Replace the Finisher Controller PCB (PCB1).

Code: E575-0001

Description: Gripper Unit Move Motor (M2) error
The gripper unit does not leave the gripper unit home position when the Gripper Unit Move Motor (M2) has been driven for 3.8 seconds.
Remedy: 1.Replace the Gripper Unit HP Sensor (S7). 2.Replace the Gripper Unit Move Motor (M2). 3.Replace the Finisher Controller PCB (PCB1).

Code: E575-0002

Description: Gripper Unit Move Motor (M2) error
The gripper unit does not return to the gripper unit home position when the Gripper Unit Move Motor (M2) has been driven for 0.1 seconds.
Remedy: 1.Replace the Gripper Unit HP Sensor (S7). 2.Replace the Gripper Unit Move Motor (M2). 3.Replace the Finisher Controller PCB (PCB1).

Code: E602-0001

Description: The built-in SD card is not detected
Remedy:

Code: E602-1105

Description: Access to the built-in SD card failed
Remedy:

Code: E711-0001

Description: Error in UFDI communication
The communication system error (such as reception timeout or checksum error) occurred.
Remedy: 1.Check and Replace the cable. 2.Replace the DC Controller PCB (PCB4). 3.Replace the Finisher Controller PCB.

Code: E713-0000

Description: Erroneous communication with finisher
The communication does not restart by the error retry after the communication failure with the finisher.
Remedy: 1.Check the cable. 2.Replace the DC Controller PCB (PCB4). 3.Replace the Finisher Controller PCB.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie