Description: There is no toner in the developing assembly; there is an error in the detection of developing toner sensor connection; there is an error in the detection of hopper toner sensor connection.
At power-on, the connection of the developing assembly toner sensor is not detected.
Remedy: - Check the connector for any fault in connection. - Replace the sensor.
Description: There is no toner in the developing assembly; there is an error in the detection of developing toner sensor connection; there is an error in the detection of hopper toner sensor connection.
At power-on, the connection of the developing hopper toner sensor is not detected.
Remedy: - Check the connector for any fault in connection. - Replace the sensor.
Description: There is a toner feed motor over-current detection error, there is a toner bottle motor connection detection error.
An over-current has been detected in the toner feed motor.
Remedy: - Check the connector for any fault in connection. - Replace the motor.
Description: There is a toner feed motor over-current detection error, there is a toner bottle motor connection detection error.
An over-current has been detected in the toner bottle motor.
Remedy: - Check the connector for any fault in connection. - Replace the motor.
Description: There is a toner feed motor over-current detection error, there is a toner bottle motor connection detection error.
At power-on, the connection of the toner bottle motor is not detected.
Remedy: - Check the connector for any fault in connection. - Replace the motor.
Description: There is a potential control error/there is an APC error.
As a result of potential control, the drum surface potential (VL2) of the background is 200 V or higher (i.e., causing a solid black image).
Remedy: - Replace the potential sensor unit. - Replace the laser scanner unit. - Replace the DC controller PCB.
Description: There is a potential control error/there is an APC error.
The primary charging output used at time of printer output and the drum surface potential after laser output is identified as being 200 V or more (i.e., causing a solid black image).
Remedy: - Replace the potential sensor unit. - Replace the laser scanner unit. - Replace the DC controller PCB.
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.