Mã lỗi Canon iR6880C — Trang 18/33
Description: Error in counter memory or SRAM
An error exists in the SRAM and FRAM counter readings
Remedy: Replace the counter PCB or SRAM
Description: There is an error in the EEPROM.
At time of start-up, a check error has occurred on the SRAM board
Remedy: Turn off the main power, and check the SRAM board; then, as necessary, replace the SRAM board, and turn on the main power.
Description: There is an error in the EEPROM.
There is a power-on error.
Remedy: Replace the reader controller PCB.
Description: There is an error in the EEPROM.
There is a write error.
Remedy: Replace the reader controller PCB.
Description: There is an error in the EEPROM.
There is a wire/read error.
Remedy: Replace the reader controller PCB.
Description: codex error
An error has occurred in the course of software decoding.
Remedy:
Description: Fault in the soft ID PCB/function
An error exists in the add-on parity.
Remedy: Reset in service mode, and replace the soft ID PCB.
Description: Fault in the soft ID PCB/function
An error has occurred in the course of full data read operation on the soft ID PCB.
Remedy: Turn off the main power, and check the connection of the soft ID PCB. If the remedy fails, replace the soft ID PCB.