• Code: E508-0001
• Description: Error in different model
  At start-up, when the pickup/delivery option for different model is detected.
• Remedy: Replace to the supported pickup option (side paper deck), delivery option (finisher) for this model.

• Code: E514-8001
• Description: Stack delivery error / End assist motor error Finisher-Z1
  The HP sensor fails to be ON within 1500ms after the return belt starts to move to its HP.
• Remedy: Check on a drive of the stack retaining roller, Replace the return belt U-turn HP sensor (SR5) , Replace the stack delivery motor (M2)

• Code: E514-8001
• Description: Stack delivery error / End assist motor error Finisher-Y1, Saddle Finisher-Y2
  The HP sensor fails to be OFF after the end assist motor rotates for a specific period of time.
• Remedy: Replace the end assist HP sensor (PI39) , Replace the end assist motor (M39)

• Code: E514-8002
• Description: Stack delivery error / End assist motor error Finisher-Z1
  The HP sensor fails to be OFF within 1500ms after the return belt starts to move to the belt contact position.
• Remedy: Check on a drive of the stack retaining roller, Replace the return belt U-turn HP sensor (SR5) , Replace the stack delivery motor (M2)

• Code: E514-8002
• Description: Stack delivery error / End assist motor error Finisher-Y1, Saddle Finisher-Y2
  The HP sensor fails to be ON after the end assist motor rotates for a specific period of time.
• Remedy: Replace the end assist HP sensor (PI39) , Replace the end assist motor (M39)

• Code: E519-8001
• Description: Gear change motor error Finisher-Y1, Saddle Finisher-Y2
  The HP sensor fails to be OFF after the end assist motor rotates for a specific period of time.
• Remedy: Replace the end assist HP sensor (PI39) , Replace the end assist motor (M39)

• Code: E519-8002
• Description: Gear change motor error Finisher-Y1, Saddle Finisher-Y2
  The HP sensor fails to be ON after the end assist motor rotates for a specific period of time.
• Remedy: Replace the end assist HP sensor (PI39) , Replace the end assist motor (M39)

• Code: E530-8001
• Description: Rear alignment error Finisher-Z1
  The HP sensor fails to be ON within 2000ms after the rear adjuster plate starts to move to its HP.
• Remedy: Replace the rear adjuster plate HP sensor (SR4) , Replace the rear adjuster plate motor (M4)