Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon iRC5058 — Trang 17/33

Code: E227-0002

Description: There is a power supply (24V) error.
At the start of a job, the 24V port is off.
Remedy: Check the power supply harness connector for connection; then, as necessary, replace the power supply.

Code: E227-0003

Description: There is a power supply (24V) error.
At the end of a job, the 24V port is off.
Remedy: Check the power supply harness connector for connection; then, as necessary, replace the power supply.

Code: E227-0004

Description: There is a power supply (24V) error.
While a load is being driven, the 24V port is off.
Remedy: Check the power supply harness connector for connection; then, as necessary, replace the power supply.

Code: E240-0000

Description: There is a DDI-P communication error.
There is a DDI-P communication error (error in communication between master and slave 0).
Remedy: Turn off the main power, and check the wiring of the DC controller PCB and the 24V system fuse; then, turn on the main power.

Code: E246-0001

Description: An error has occurred in the course of writing to the counter memory.
Normal access to the FRAM PCB is not possible. A value is written to a specific area for a check on connection to the FRAM PCB; when read back, however, it is not the value that has been written.
Remedy: Turn off the main power, and check the connection of the counter PCB. If the remedy fails, replace the counter PCB.

Code: E246-0002

Description: An error has occurred in the course of writing to the counter memory.
When the soft ID of FRAM is being repaired, FRAM is not in an initialized condition.
Remedy: Replace the counter PCB.

Code: E246-0003

Description: An error has occurred in the course of writing to the counter memory.
After an increase in the count, data is read into FRAM; when it is read back and compared, it is not the value that has been read into FRAM.
Remedy: Replace the counter PCB.

Code: E246-0004

Description: An error has occurred in the course of writing to the counter memory.
A second after repair (from SRAM to FRAM) brings out different SRAM and FRAM counter readings. An attempt at repair has failed.
Remedy: Turn off the main power, and check the connector of the counter PCB. If repair fails, replace the counter PCB.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie