• Code: E004-0020
• Description: There is an error in the fixing assembly protection circuit. There is an open circuit or poor contact in the main thermistor (THM1, THM2, THM3) or sub thermistor (TH4, THM5, THM6). The AC driver PCB or the DC controller PCB has a fault.
  The outside heating roller thermistor has an open circuit.
• Remedy: Check the main thermistor and the sub thermistor for an open circuit and poor contact; then, reset in service mode: COPIER>FUNCTION>CLEAR>ERR.

• Code: E004-0030
• Description: There is an error in the fixing assembly protection circuit. There is an open circuit or poor contact in the main thermistor (THM1, THM2, THM3) or sub thermistor (TH4, THM5, THM6). The AC driver PCB or the DC controller PCB has a fault.
  The pressure roller thermistor has an open circuit.
• Remedy: Check the main thermistor and the sub thermistor for an open circuit and poor contact; then, reset in service mode: COPIER>FUNCTION>CLEAR>ERR.

• Code: E005-0000
• Description: There is an error in the take-up mechanism of the web.
  The web of the fixing assembly has been fully taken up. After the web sensor has detected an off state, the count has exceeded 3000. The web length sensor (PS20) is faulty. The DC controller PCB is faulty.
• Remedy: Reset in service mode: COPIER>FUNCTION>CLEAR>ERR. If you have replaced the web, reset the reading in the following, and turn off and then on the power: COPIER>COUNTER>DRBL-1>FIX-WEB.

• Code: E005-0010
• Description: There is an error in the take-up mechanism of the web.
  The drive solenoid of the fixing assembly is not connected.
• Remedy: Check the drive solenoid of the fixing web for disconnection; then, reset in service mode: COPIER>FUNCTION>CLEAR>ERR.

• Code: E006-0001
• Description: The fixing assembly has a comparison error.
  The fixing drawer has been identified as being disconnected.
• Remedy: Check the connector of the drive solenoid of the fixing web; then, turn off and then on the main power.

• Code: E008-0001
• Description: There is an error in relation to the life of the fixing assembly.
  The counter reading for the fixing roller has exceeded a specific count
• Remedy: When you have replaced the fixing roller, reset in service mode, and turn off and then on the main power: COPIER>COUNTER>DRBL-1>FX-UP-RL.

• Code: E009-00FF
• Description: There is an outside heating roller shift error. The outside heating roller shift motor (M22) is faulty. The outside heating roller HP sensor (PS21) is faulty. The DC controller PCB is faulty.
  The outside heating roller remains in contact with the fixing roller
• Remedy: Check the outside heating roller shift motor and the fixing motor; then, turn off and then on the main power.

• Code: E012-0001
• Description: There is an error in the drum/ITB motor.
  After motor start-up, a lock state is not identified for 1 sec or more.
• Remedy: Check the area around the photosensitive drum and the intermediate transfer belt; then, turn off and then on the main power.