Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon LBP3050

Code: E000

Description: Error in startup
Causes: - The detected temperature of the thermistor does not reach 35 deg C within approx. 1.5 sec of the heater being turned on. - The detected temperature of the thermistor is 100 deg C or lower in standby mode.
Remedy: - Check connectors on the fixing film unit. - Replace the fixing film unit. - Replace the engine controller PCB.

Code: E001

Description: Error in abnormally high temperature
Causes: The detected temperature of the thermistor is 220 deg C or higher 30 times consecutively.
Remedy: - Check connectors on the fixing film unit. - Replace the fixing film unit. - Replace the engine controller PCB.

Code: E003

Description: Error in abnormally low temperature
Causes: - After the heater is turned on, the detected temperature of the thermistor is 100 deg C or lower at the time of printing after reaching 50 deg C. - After the heater is turned on, the detected temperature of the thermistor is 55 deg C or lower at paper intervals or in cleaning mode after reaching 50 deg C.
Remedy: - Check connectors on the fixing film unit. - Replace the fixing film unit. - Replace the engine controller PCB.

Code: E004

Description: Error in fixing heater drive circuitry (For 200V machines only)
Causes: An abnormal frequency is detected on the fixing drive circuit within approx. 3.3 sec of the power being turned on.
Remedy: - Check connectors on the fixing film unit. - Replace the fixing film unit. - Replace the engine controller PCB.

Code: E100

Description: Error in Scanner Unit
Causes: - At startup of the scanner, /BDI signal cannot be detected within 0.1 sec after forced acceleration of the scanner motor. - At startup of the scanner during activation of the scanner motor, the motor rotation exceeds the range of specified value (98.3 to 102.1%). - After startup of the scanner is correctly completed, /BDI signal exceeds the specified cycle 10 times consecutively.
Remedy: Check connectors on the scanner unit - Replace the scanner unit. - Replace the engine controller PCB

Code: E196

Description: Error in DCON communication
Causes: An error in data communication occurs in the Main controller.
Remedy: - Replace the engine controller PCB

Code: E733

Description: error in Engine communication
Causes: An error in data communication occurs in the Engine controller.
Remedy: - Turn OFF and then ON the power. - Replace the Engine Controller PCB.

Code: E747

Description: Error in main controller memory
Causes: Data of EEPROM on the main controller cannot be read/written.
Remedy: - Replace the main controller PCB
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie