Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon LBP6280K

Code: A5-XX

Description: There is a fault in the software program of the video controller.
Causes:
Remedy: - Turn off and then back on the power. - Replace the video controller board.

Code: A7-XX

Description: There is an error in the software program of the video controller.
Causes:
Remedy: 1. Turn off and then back on the power. 2. If remedy 1 above fails, replace the controller board.

Code: D7-XX

Description: A fault has occurred the firmware of the PCL translator.
Causes:
Remedy: 1. Turn off and then on the power. 2. If remedy 2 above fails, replace the controller board.

Code: E000-0000

Description: Fixing fault
Causes: After the fixing heater has gone on, the reading is not -5 deg C of the target temperature within 75 sec. Cause The fixing film unit is faulty. The engine controller PCB is faulty.
Remedy: - Replace the fixing film unit. - Replace the engine controller PCB.

Code: E000-0001

Description: Fixing fault
Causes: After the fixing heater has gone on, the reading of the main thermistor is not 50 deg C within about 1.5 sec. Cause The fixing film unit is faulty. The engine controller PCB is faulty.
Remedy: - Replace the fixing film unit. - Replace the engine controller PCB.

Code: E001-0000

Description: Fixing error high temperature
Causes: A temperature of the main thermistor is detected 240 degrees Celsius for one second. Cause The main thermistor is faulty. The engine controller PCB is faulty.
Remedy: - Replace the fixing film unit. - Replace the engine controller PCB.

Code: E001-0001

Description: Fixing error high temperature
Causes: A temperature of the sub-thermistor is detected 320 degrees Celsius or higher for approximately 2.6 seconds. Cause The sub/main thermistor is faulty. The engine controller PCB is faulty.
Remedy: - Replace the fixing film unit. - Replace the engine controller PCB.

Code: E003-0000

Description: Fixing low temperature
Causes: The temperature of the main thermistor shows 20 deg C or below for 300 ms continuously after the temperature of the main thermistor exceeds 50 deg C at least once. Cause The main thermistor is faulty. The engine controller PCB is faulty. The connector is in poor contact. The harness is faulty.
Remedy: - Replace the fixing film unit. - Replace the engine controller PCB.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie