Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon MF621Cn — Trang 4/9

Code: 04 0071

Description: Sequence Error
Causes:
Remedy:

Code: 04 0094

Description: Document End Sensor / Document Sensor
Causes: PS702/PS703
Remedy:

Code: E000 0000

Description: Error in temperature rising of Fixing Assembly
Causes: Temperature of the Fixing Assembly did not reach a certain temperature within the specified period of time.
Remedy: 1. Check the connector connection between the Fixing Assembly and the DC Controller PCB. 2. Replace the Fixing Assembly. 3. Replace the DC Controller PCB.

Code: E001 0000

Description: Abnormal high temperature of Fixing Assembly
Causes: It was detected that the temperature of the Fixing Assembly was abnormally high.
Remedy: 1. Check the connector between the Fixing Assembly and the DC Controller PCB. 2. Replace the Fixing Assembly. 3. Replace the DC Controller PCB.

Code: E003 0000

Description: Abnormal low temperature of Fixing Assembly
Causes: It was detected that the temperature of the Fixing Assembly was abnormally low.
Remedy: 1. Check the connector between the Fixing Assembly and the DC Controller PCB. 2. Replace the Fixing Assembly. 3. Replace the DC Controller PCB.

Code: E004 0000

Description: Error in fixing power supply drive circuit
Causes: The zero cross signal was not detected for the specified period of time or more.
Remedy: 1. Check the connector connection between the Fixing Assembly and the DC Controller PCB. 2. Replace the Fixing Assembly. 3. Replace the DC Controller PCB.

Code: E012 0000

Description: Revolution of the ITB Motor did not reach the specified value
Causes: The cycle of the ITB Motor speed detection signal did not become the specified cycle since the ITB Motor started to be driven.
Remedy: 1. Check the connector between the ITB Motor and the DC Controller PCB. 2. Replace the ITB Motor. 3. Replace the DC Controller PCB.

Code: E012 0001

Description: Revolution of the ITB Motor was out of the specified range
Causes: After the cycle of the ITB Motor speed detection signal became the specified cycle once, it deviated from the specified cycle.
Remedy: 1. Check the connector between the ITB Motor and the DC Controller PCB. 2. Replace the ITB Motor. 3. Replace the DC Controller PCB.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie