Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon NP8530

Code: E000

Description: The surface temperature of the fixing assembly upper roller fails to rise by a specified value within 90 sec after power-on. The surface temperature of the fixing assembly upper roller fails to reach 150 C within 8 min after power -on. The surface temperature of the fixing assembly upper roller fails to reach 180 C within 5 min after it has reached 150 C. The surface temperature of the fixing assembly upper roller falls below 50 C in standby.

Code: E001

Description: The surface temperature of the fixing assembly upper roller exceeds 250 C.

Code: E005

Description: The cleaning belt inside the fixing assembly has been taken up more than a specified length.

Code: E010

Description: After generation of the main motor drive signal, two or more pulses are not received within 2 sec.

Code: E020

Description: The accumulative time during which the toner supply signal (TSP) has been generated by the developing assembly reaches 3 min.

Code: E050

Description: The holding tray home position signal (THP) is not generated within 4 sec while the holding tray motor drive signal (TMDP1,2) is being generated. The holding tray home position signal (THP) is generated 1 sec or more while the holding tray motor drive signal (TMDP1.2) is being generated.

Code: E13

Description: The error detection circuit on the waste toner feed motor driver PCB has detected on overcurrent.

Code: E203

Description: Input of two or more clock pulses is not received within 2 sec from the scanner motor drive signal is generated.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie