Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon Satera MF7210 — Trang 4/8

Code: E001-0001

Description: Abnormally high temperature (detected by sub thermistor)
The sub thermistor detected an abnormally high temperature (300 deg C) during temperature control.
Remedy: - Check the connector of the fixing film unit. - Replace the fixing film unit. - Replace the DC controller PCB.

Code: E002-0000

Description: Low temperature during temperature control.
The target temperature is not reached during temperature control.
Remedy: - Check the connector of the fixing film unit. - Replace the fixing film unit. - Replace the DC controller PCB.

Code: E003-0000

Description: Abnormally low temperature (detected by main thermistor)
After the temperature detected by the main thermistor has reached the specified value, it does not reach the specified value during initial rotation.
Remedy: - Check the connector of the fixing film unit. - Replace the fixing film unit. - Replace the DC controller PCB.

Code: E003-0001

Description: Abnormally low temperature (detected by sub thermistor)
After the temperature detected by the sub thermistor has reached the specified value, it does not reach the specified value during initial rotation.
Remedy: - Check the connector of the fixing film unit. - Replace the fixing film unit. - Replace the DC controller PCB.

Code: E007-0000

Description: Fixing film sensor failure
The fixing film sensor is faulty.
Remedy: - Check the connector of the fixing film sensor. - Replace the fixing film sensor. - Replace the DC controller PCB.

Code: E010-0000

Description: Main motor failure
The main motor is faulty.
Remedy: - Check the connector of the main motor. - Replace the main motor. - Replace the DC controller PCB.

Code: E019-0000

Description: Waste toner full detection
The waste toner full state was detected.
Remedy: Replace the drum unit.

Code: E019-0001

Description: Waster toner full detection sensor is faulty.
The waste toner full state was detected continuously for five or more seconds while the main motor was turning.
Remedy: - Check the connector of the waster toner full sensor. - Replace the waste toner full sensor. - Replace the DC controller PCB.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie