• Code: 00020003
• Description: Boot program sum error
  The printer causes this error and stops operation when it detects that the boot program of the firmware is corrupted. This error occurs only when turning the power ON.
• Causes: • Failed to install the program. • Flash ROM failure • SDRAM failure • The address/data bus on the Main Board is broken or its contact is poor.
• Remedy: 1. Installing Firmware 2. Replace the BOARD ASSY., MAIN .

• Code: 0002000A
• Description: Program load error
  A sum check error on the program area of the RAM
• Causes: • Malfunction of the program • SDRAM failure • The address/data bus on the Main Board is broken or its contact is poor.
• Remedy: 1. Installing Firmware 2. Replace the BOARD ASSY., MAIN .

• Code: 0002000B
• Description: The internal memory is insufficient.
  This error occurs when the cache area is judged as insufficient. The cache insufficient condition is likely to be caused by using the work area of the memory with unmatched interface mode settings or invalid commands. The printer stops operation when the error occurs.
• Causes: Malfunction of the program
• Remedy: 1. Check the interface mode setting 2. Installing Firmware 3. Replace the BOARD ASSY., MAIN .

• Code: 0DXXXXXX
• Description: An error code for debugging
• Causes: • Board failure • SDRAM failure • Cold soldering of the Flash ROM, ASIC, or CPU. • Malfunction of the program • Failed to generate commands for the printer
• Remedy: 1. Installing Firmware 2. Replace the BOARD ASSY., MAIN .

• Code: 0EXXXXXX
• Description: A time-lag of the RTC timer
  This error occurs when the printer failed to communicate with the RTC chip on the Main Board. • 0Exxyyzz: xx = Location where a compare error occurred (00 = LTMR1, 01 = LTMR0, 02 = MIN counter) yy = Setting value (writing value) zz = Setting result (a value read when comparing)
• Causes:
• Remedy: Start up the printer in the Serviceman mode, and set the date and time setting using the “RTC & USB ID & IEEE1394 ID” Basic Adjustment menu provided in the Adjustment Program.

• Code: 100000E0
• Description: CPU address error (misalignment of loading)
• Causes: • Board failure • CPU cold soldering • Malfunction of the program, Failed to generate commands for the printer
• Remedy: 1. Installing Firmware 2. Replace the BOARD ASSY., MAIN .

• Code: 10000100
• Description: CPU address error (misalignment of storing)
• Causes: • Board failure • CPU cold soldering • Malfunction of the program, Failed to generate commands for the printer
• Remedy: 1. Installing Firmware 2. Replace the BOARD ASSY., MAIN .

• Code: 10000180
• Description: CPU reserved command code exception error
• Causes: • Board failure • CPU cold soldering • Malfunction of the program, Failed to generate commands for the printer
• Remedy: 1. Installing Firmware 2. Replace the BOARD ASSY., MAIN .