Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Epson Stylus Pro 9600 — Trang 4/6

Code: 00010036

Description: Type-B board installation error
Causes: A Type-B board lower than level 2 is installed.
Remedy: Remove the installed Type-B board.

Code: 00010037

Description: Head thermistor error
Causes: • The head thermistor is faulty. • The temperature of the thermistor is lower than minus 20 degrees C or higher than 100 degrees C. • The Head FFC is disconnected, or its contact is poor.
Remedy: 1. Check the connection status of the Head FFC and correct it if necessary. 2. Replace the PRINT HEAD .

Code: 00010038

Description: Transistor thermistor error
Causes: • The transistor thermistor is faulty. • The temperature of the thermistor is lower than minus 20 degrees C or higher than 100 degrees C.
Remedy: Replace the BOARD ASSY., MAIN .

Code: 0001003E

Description: Pressure Sensor failure
Causes: • The Pressure Sensor is ON when an ink pressurizing operation is not performed. (disconnection of the Pressure Sensor connector, malfunction of the Pressure Sensor, or Main Board failure) • The inside pressure cannot be reduced to the same level as atmospheric pressure. (valve failure, Regulator Solenoid failure, Pressure Tube failure, or Main Board failure)
Remedy: 1. Reconnect the Pressure Sensor connector securely. 2. Connect the Pressure Tube. 3. Replace the PUMP ASSY., SUPPLY . 4. Replace the BOARD ASSY., MAIN .

Code: 0001003F

Description: The Pressure Motor reached its end of life.
Causes: The cumulative number of steps of the Pressure Motor reached the prescribed upper limit
Remedy: Replace the PUMP ASSY., SUPPLY ., and reset the life counter of the Pressure Pump Unit using the Adjustment Program.

Code: 00010040

Description: Printing position error
Causes: • Exact detection of printing positions is impossible due to dirt or scratches on the Timing Fence or the CR Encoder. • Malfunction of the program
Remedy: 1. Replace the SCALE, CR . 2. Replace the CR Encoder Sensor . 3. Execute the CR Encoder Sensor Adjustment . 4. Installing Firmware

Code: 00020000

Description: NVRAM error
The printer causes this error and stops operation when it detects that parameters stored on the NVRAM are corrupted.
Causes: NVRAM erasing or writing error (every 2-byte is checked)
Remedy: Replace the BOARD ASSY., MAIN .

Code: 00020002

Description: SDRAM error
The printer causes this error and stops operation when it detects a bit error by the SDRAM memory check performed during the power-on sequence.
Causes: • SDRAM reading/writing error • SDRAM failure • The address/data bus on the Main Board is broken or its contact is poor.
Remedy: Replace the BOARD ASSY., MAIN .
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie